DAGE-MTI DC-200 Manuel d'utilisateur

User’s Manual DAGE-MTI Investigater CCD Camera Gater & Frame Grabber

GATE For cameras other than the CCD100, this BNC provides the gating pulse. Directly connected to the CAMERA connector, the gate pulse is available

VIDEO IN The camera's video is placed into the InvestiGater either through this BNC or through the CAMERA connector. Care should be taken so a

Specifications: Resolution: 756(H) x 480(V) x 8 bits (RS-170) 754(H) x 580(V) x 8 bits (CCIR) Pixel Clock Freq: 14.318 MHz (RS-170) 14.1875 MHz (C

Troubleshooting No Power Lights (Check or try the following): 1. InvestiGater Power Switch On? 2. External Power Supply Attached? 3. AC Power

Warranty The DAGE-MTI InvestiGater is warranted to be free of defects in material and workmanship in normal use for a period of one year from the ori

Limitations 1. This warranty is valid only if the malfunctioning unit is returned to DAGE-MTI service depot. This warranty does not cover on-location

DAGE-MTI Inc. 701 N. Roeske Ave. Michigan City, IN 46360 (219) 872-5514 Fax: (219) 872-5559 E-mail: [email protected] http://www.dagemti.com

Purchaser’s Record Model Name: DAGE-MTI Investigater Serial Number: Dealer’s Name: Dealer’s Address: Dealer’s Phone Number:

Introduction The DAGE-MTI InvestiGater provides a solution of obtaining low light level images from DAGE-MTI monochrome CCD cameras by gating, grabbi

Installation The InvestiGater easily connects to the CCD100 through a single cable. This standard S-video type cable (Dage P/N 737980-01) provides P

MONITORInvestiGaterCAMERAVID OUTPOWERTABLE TOPSWITCHINGP/SRC300AUXTABLE TOPSWITCHINGP/SCAMERAVID OUTGATEVID INCCD300HEADPOWERCABLE P/N 835320-08 Fig

Operation Figure 4: Dage-MTI InvestiGater Front Panel The InvestiGater's front panel allows the user to switch between the stored image and th

SIGNAL LEVEL The output video level of the InvestiGater is sensed and drives the SIG LEV LED. The LED lights Yellow when the output video is too low

Figure 5: Dage-MTI InvestiGater Rear Panel SGL/RUN This switch determines whether the gating process of the InvestiGater is a single event or an

Pin-out of the POWER Connector is as follows: PIN # FUNCTION 1 GND 2 GND 3 +5V Power In 4 -12V Power In 5 +12V Power In 24153